Blog

Chevy Cruze Rough Idling and Stalling Problems. How to Fix?

In our article today, we take a look at one of the Chevy Cruze issues, which are rough idling and stalling. This is a nagging problem for many Chevy Cruze owners.

BMW Exhaust Back Pressure Sensor Symptoms and Ways to Fix

  This article will explore the possible symptoms of a faulty Exhaust Back Pressure Sensor. We will also provide potential solutions to a faulty exhaust back pressure sensor in your BMW.  

Car Battery Dies Right After Turning Off — What's Wrong?

If your car battery dies after turning off your car, it could be due to a parasitic drain, weak battery, faulty charging system, Faulty BCM. etc.

Is There an Additive to Quiet Noisy Differentials? Why Won't It Help?

This article will give you all you need to know about differential noise and the use of additives to address it. 

Rear Drum Brakes Locked Up After Sitting: What to Do?

  See various expert solutions to the problem of your rear drum brakes getting locked up after sitting. You will also know its causes and tips for prevention.  

1KD-FTV Performance Upgrades: Here's What You Can Do

1KD-FTV is known for its power and good fuel consumption, but can you make it even better using certain upgrades and improvements?

Will a Bad Fuel Filter Throw a Code? Tricky Codes and Ways to Fix

The fuel filter isn't directly monitored by an engine control module but it can trigger several different codes and light up the check engine light on your dash.

How to Set Up Subaru Starlink Remote Start? Guide and Considerations

To set up a Subaru Starlink Remote Start, verify your vehicle's compatibility. Secondly, sign up for a Subaru Starlink account. 

Why Am I Feeling Engine Heat Inside the Car? Most Common Reasons

Abnormal heating of your car’s passenger cabin is a symptom of severe engine malfunction. It is wise to get your car accurately diagnosed by a professional.

How to Remove Black Soot from Exhaust? And Why Is It There?

This article will detail how to clean your car’s exhaust pipe and go a step further. We will also reveal the probable causes of the black soot.

Ring and Pinion Noise on Acceleration – What's Wrong?

Ring and pinion noises mostly happen when the ring and pinion gear is not properly installed or needs adjustment.

Honda VSA Light and No Acceleration - What's Wrong?

A VSA light indicates an issue with the Vehicle’s Stability Assist System. The VSA detects situations where the driver steers more than usual or less than appropriate.

Car Burns 1 Quart of Oil Every 1000 Miles. Disaster or Not?

If your engine burns 1 quart of oil every 1000 miles, it’s still OK but on the edge of being bad, so you should track the situation carefully. 

Can I Put a Wet Key Fob in Rice? Best Methods to Avoid Problems

You can put a wet key fob in rice; however, this common DIY method is not the most effective method to dry out your key fob. 

Can a Bad Relay Drain Your Battery? Checking and Fixing the Issue

A bad relay can drain your car batteries when it doesn’t cut power when it should and leaves the power to remain active on many components of the car.

Honda CR-V "Brake System Problem", Car Won't Start — Why?

If you get a "Brake system problem" error message and the car won't start, the problem could be a dead battery or brakes.

I Spilled Gasoline on My Hands - What Should I Do Right Now?

In short, the first thing you should do after spilling gasoline on your hands is to move away from the source of gasoline and wash your hands.

What Effect Does Sport Mode Have on 2023 Rogue? Magic or Illusion?

This article will cover what the Sport Mode is, its effect on the 2023 Rogue, and answer whether its effects are magic or just an illusion.

«Engine Hot, AC Off», But Temp Gauge Reads Cold. What's Wrong?

  This article will cover the possible reasons your temperature gauge is reading cold while your engine is hot and AC is off to help you narrow down to what the issue could be.  

Porting Cylinder Head: Pros and Cons. How Much Will It Cost?

Cylinder head porting is the process of increasing the size and smoothing out the rough edges of cylinder head intake and exhaust ports to increase airflow.