When your Mercedes says “Reduce Oil Level”, it means that the sensor of the oil level registers too much oil. This can happen when you overfill the engine with oil.
In this article, I will tell you about the 1.5L Turbo engine that powers the Mitsubishi Eclipse Cross and will focus on its advantages, specs, and common problems.
The error message “Stop safely. Vehicle may shut off soon” usually means that there is a problem with one of the batteries (yes, you obviously have two batteries in your Jeep).
When it comes to Honda’s 10-speed automatic transmission, it’s overall good and reliable. But as with any mechanism in the world, it comes with its share of issues.
If your VW says “Transmission in emergency mode, you can continue driving”, it means that the control units registered some anomaly in the work of the transmission.
If you see "Add Oil Immediately", you should check the oil level using your MMI or dipstick in an Audi vehicle. Also, if the level is really low, you should add some oil.
The Aisin TF-80SC is a 6-speed automatic transmission made by a famous Japanese manufacturer. The oil change interval is not stated but recommended at 40,000 miles.
Whenever your Jeep says “Service Hill Holder”, it may refuse to start or even turn off, show the ESC warning light on the dash, or act weirdly and freak out some other way.
The very common thing for 2007-2010 Land Rover vehicles with air suspension is to see this message on the dash: “Suspension Fault, Normal Height Only”.
If your Ford says “High Engine Temperature, Stop Safely”, immediately do what the car asks you to do. You need to stop your car as soon as possible and turn off your engine.
The ACC Deactivated message may be triggered by weather or some technical conditions in your vehicle. It’s important to inspect the car after you see this warning.
When you see the “Key fob has left the vehicle” message in a Jeep car, the fob lost connection with the vehicle’s antenna and it’s most likely because of the fob battery.
If you get the “Service Electronic Parking Brake” message in your Jeep, it may be the battery issue. Also, this happens because of a software glitch or electrical problems.
If your truck starts on its own, it can happen because of the faulty ignition switch, a low battery that is being changed, and also some glitches in control units.